20 Most Recent 2007 Ford Mustang GT California Special Convertible Questions & Answers

Here: Ford Mustang Fuse box Years of production 2005 2006 2007 2008 2009 2010...

Use a chisel use caution not t o hit the rim split the nut .

All those seat motors are under the seat. The forward and back motor has cables that are used to move the seat. If a plug are cable came loose, easy to find. Can be a pain to fix. Not much room to work. Some times the seat has to come out. I think I would be more worried to what damage is on the bottom of the car first. Just saying.

This is a common problem. At the factory, the top material is bonded to the glass. That bond is breaking down. You can use Gorilla taps or urethane adhesive, but you will eventually need a new window unit. The window unit is separate from the actual top. The top must be partially removed to replace the window unit. Karl at aoksales.com

The rear window for that top is a seperate curtain.
Replacement is best left to a professional.
You should cantact an automotive trim shop (upholstery) for them to quote it.

The way it is replaced, you have to take the top loose, roll it forward, replace the window curtain, reinstall the top. Depending on the condition if the top, it may need replacement also. That is best determined by the shop that does the work.
This is not recommend as a DIY project. I worked in a trim shop for years, and they are not easy.

This problem is very common and is known as delamination.
If the problem is not too far advanced, you can repair it with Urethane adhesive. It is used by glass shops to install windshields.
Your top and window unit are two separate parts.
If the problem is beyond repair, you will need to remove the rear half of the top and replace the window unit.

Karl at topgunwon.com

Usually in most cases when a transmission wont go in reverse, is not good. I would try to have the transmission fluid and filter replaced. That might fix it and save you a few hundred dollars. If it does not help, then you are going to ned to take your car and have the transmission fixed.

Disconnect the battery terminal for 10 minutes

Re;2007 mustang will turn over and even start but dies out immediately a if you killed the ignition. Engine cranks & starts,stalls w/key released to 'run' position ?? If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

it sounds like the dog gear on the motor is stuck, try putting it in gear and rocking the car back and forth a few times, take it out of gear and try the starter again

No help at all

Have the charging system tested and the battery as well.

This is similar to a solution I offered another member earlier. If the pump runs at all, but the top won't move, then you most likely have lost some of all of the hydraulic fluid. The most likely source of the leak is one or both bad lift cylinders. If this has happened, the pump is probably screwed now, too. Your best bet is to plan on replacing the pump, both lift cylinders, and all the lines. If you try to save a few bucks by swapping out just the cylinders (for example), you will probably be back under the seat to replace the rest of the system in short order. From my own (unpleasant) experience, plan on doing it right the first time, and you won't have to do it twice.