20 Most Recent 2009 Kia Sorento 3.3 Questions & Answers

How to Change Fuel Filter on KIA Sorento eHow try that :)

You just go to the link I attached I'm sure you will get the solution of your problem KIA Sorento V6 3 3L 2009 OEM Factory SHOP Service repair manual FSM...

The oil light will come on when ever pressure is low it ct can be as little as the oil pressure sensor is going out or you may have a blockage somewhere in the oil system try doing an oil change with mobile1 oil this may help if there is a small blockage but defiantly get the sensor checked first

Sounds like a wiring problem or a blown fusible link.

Sounds like a misfire condition... This condition will set trouble codes that you can scan for at your favorite local auto parts store for free. Just go up to the parts counter and ask them to scan your engine codes. This will give you a clue as to what is going wrong with your car. It could be more than one component causing the problem.

very hard to understand the question- but im guessing your car died while you were on the road? if so i would start with checking the alternator I’m happy to assist further over the phone at https://www.6ya.com/expert/josh_8f8ad0a8f7e0e6d3

check the alternator maybe is bad and so it drained your battery, jumpped and try to started sould start

may be your power steering pump whining. Check fluid first, then if it's up, start the car up and have someone turn the wheel back and forth a few times. Listen to see if there is more or less noise when this happens. Does the noise go away after it warms up?

Hi Cristina, Take the vehicle for a diagnostic inspection and the scan will tell the technician what is wrong and where. Regards John

leds might be going out, which is unlikely with that new of a car. If you have to reset your computer after an oil change or anything of that nature, that may be your problem

Dont know offhand to be honest ,if it is a timing chain then its running in oil and should ever need changing although the tensioners may need changing after 250,000 miles or so but again this depends how regular the oil is changed i recomend around 5000miles with a oil filter every thrid oil change but opinions vary on this

In the link and a video as well. NOTE: they are POUND INCH not Foot Pounds.

Torque Pattern for Valve Cover? - Kia Forum

kia-forums.com https://www.kia-forums.com > threads > torque-patter... Sep 17, 2013 - show the locations of the bolts on the "Cylinder Head Cover" --aka valve cover-- and they provide the torque at 35-52 lb-in (4-6Nm), but they ... Valve Cover Gasket help Apr 28, 2012 Torque specs and sequence for intake bolts Jul 10, 2022 Need Bolt Pattern for Valve Cover, please help? May 15, 2018 torque specs? Mar 20, 2017 More results from www.kia-forums.com ..