20 Most Recent
2008 Jeep Commander 3.7 Questions & Answers
2008 JEEP COMMANDER 3.7L ATF CAPACITY?
A general rule to use is to carefully fill the transmission through the fill hole, (The higher of the two holes), When the fluid is level with this hole, (it'll start leaking back out), the amount is at a safe level and will be near the correct amount needed. Roughly one quart or just over one litre.
12/16/2019 8:10:11 PM •
2008 Jeep...
•
Answered
on Dec 16, 2019
How to remove heated rear-vision mirrors glass only
most mirrors have push pins holding the top of the glass to the movable backing plate and 2 lower tabs that slide into slots first.
gently pry on the top of the glass toward you and the glass should release .then lift up to get the tabs out of the bottom 2 slots.
3/29/2015 6:24:41 AM •
2008 Jeep...
•
Answered
on Mar 29, 2015
Radio Problem?
First you need to know if you DO even have a factory preminum system.
3/14/2014 4:59:40 AM •
2008 Jeep...
•
Answered
on Mar 14, 2014
Where is neutral safety on 2008 jeep commander
The neutral safety switch for an automatic transmission is located inside the transmission case or in the linkage that allows the vehicle to shift gears. This switch prevents you from starting the engine when the transmission is in any gear other than Park or Neutral.
Where is the a/c drain located on a 2008 jeep
If you look at where the heater core pipes run into and out of the firewall under the hood. there should be a small rubber/plastic tube coming out of the firewall near these pipes. this is the drain.
I'm changing spark plugs on
Yes you need 16 plugs. You will need a good selection of different length 3/8" extensions, as well as a good plug socket with the rubber inside to grip the plug connector.
You should also invest in a rubber plug installer tool (they are about 6" long and will pop over the terminal of the plug and can be used as a handle to make installation easier)
These things are a pain to change, but it can be done without removing anything major. I use an old quilt over the engine so I can lay over the top to make reaching things easier. Have fun, good luck.
2009 Jeep Commander --- Ignition problems. For
Hey Anon, Is this a total electronic key,,(push button start)..if so, its an electrical issue. If its a standard key urn ignition. try some DRY graphite on the key.. it will lubricate the switch without the mess of liquids... put the key in and out several times, put some more dry graphite on the key and repeat.. give this some time to work,, if this does not improve the switch.. its time for a new switch assy,
Not finding what you are looking for?