20 Most Recent 2007 Ford Mustang Coupe Questions & Answers

I have 2005 mustang and had the same problem 4 yrs after I bought my .Mustang when it was still under the warranty I took it to the dealer where I purchased vehicle.They charged me $150.00 to change the cabin air filter they said the old one was blocked with leaves and suggested not to park vehicle under trees which is kind of hard to do when I live on a street with a lot of trees. Everything was fine until 2 years later it started leaking in passenger side again.Pulled cabin air filter saw no leaves.Of course now warranty ran out .I went on a mustang web forum to find there were other people with same problem and not just a mustang problem there were other makes and models having same problems .One person fixed the problem. Here is the fix. Pop your hood look under where the cowl grill sits on the right and left side there is a rubber drain on each side( hard to see)so feel with your fingers check to see if they are blocked with dirt or leaves if so clean them so water can flow through them when it rains .That is what was causing water to come in on my passenger side right underneath the glove box in my mustang now every few months I check to see if they are blocked I have not had anymore problems with water coming in on passenger side . Sad thing is when i purchased my mustang i wish the dealer would have told me not to park my car under trees so i wouldn\'t have a water I would have thought twice about buying a car that you can\'t park under trees because I live in an area where there is a whole lot of trees.Thanks a lot Ford for designing such a crappy car !!!! Good luck I hope this fixes your water problem.

run the fault codes to determine if it is an accelerator position sensor or a throttle position motor problem

Are you using oem tires and wheels? Is it rubbing the wheel or tire? Tires are properly inflated? Is the caliper assembly loose? I can't see much from here.

The washer is in front of the Balancer, should come off pretty easy from that point with a puller, make sure the puller you use has a tip that snaps on so it doesn't get into the crankshaft threads!

The windshield wiper motor is a smart wiper motor with an integrated electronics module. The internal components of the motor are the high/low relay, washer pump relay, and the run/park relay and associated electronics. The windshield wiper motor receives its inputs from the windshield wiper/washer switch. These signals are ground reference signals. When the switch is placed in different positions, various input signals are selected and sent through circuits to the motor. The windshield wiper motor module identifies these selected input signals and activates the motor to the selected function.! Your probably going to need a new wiper motor ! ! ! But you should always test before replacing parts ! Visual Inspection Chart Mechanical Electrical

• Windshield washer pump hoses
• Windshield wiper mounting arm and pivot shaft

• Bussed electrical center (BEC) fuse 10 (30A)
• Smart junction box (SJB) fuse 3 (10A)
• Circuitry
• Windshield wiper motor
• Windshield washer pump
• Windshield wiper/washer switch

• The wipers stay on continuously

• Circuitry
• Windshield wiper motor
• Windshield wiper/washer switch

• Go To Pinpoint Test C .

PINPOINT TEST C: THE WIPERS STAY ON CONTINUOUSLY CAUTION: Use the correct probe adaptor(s) when making measurements. Failure to use the correct probe adaptor(s) may damage the connector. Test Step Result / Action to Take C1 CHECK THE WINDSHIELD WIPER/WASHER SWITCH

• Key in OFF position.
• Disconnect: Windshield Wiper/Washer Switch C2137.
• Carry out the windshield wiper/washer switch component test. Refer to Wiring Diagrams Cell 149 for schematic and connector information.
• Does the windshield wiper/washer switch pass the component test?

Yes GO to C2 . No INSTALL a new windshield wiper/washer switch. REFER to Wiper/Washer Switch in this section. C2 CHECK CIRCUITS 56 (DB/OG), 58 (WH), 61 (YE/RD), AND 63 (RD) FOR A SHORT TO GROUND

• Disconnect: Windshield Wiper Motor C125.
• Measure the resistance between the windshield wiper motor C125, harness side and ground as follows: Windshield Wiper Motor C125 Pin Circuit C125-10 56 (DB/OG) C125-11 58 (WH) C125-1 63 (RD) C125-9 61 (YE/RD)
• Are the resistances greater than 10,000 ohms?

Yes GO to C3 . No REPAIR the circuit(s). TEST the system for normal operation. C3 CHECK FOR CORRECT WINDSHIELD WIPER MOTOR OPERATION

• Disconnect all the windshield wiper motor connectors.
• Check for:
  • corrosion.
  • pushed-out pins.
• Connect all the windshield wiper motor connectors and make sure they seat correctly.
• Operate the system and verify the concern is still present.
• Is the concern still present?

Yes INSTALL a new windshield wiper motor. REFER to Wiper Motor in this section. TEST the system for normal operation. No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. You

It is warning you that you have a service engine code..Either you need an engine service or you have a trouble code...You need to have it scanned by a code reader...You can maybe get it scanned for free at the right garage or parts store...Have this done as soon as possible to avoid damage...

Could be a fault with the self park switch that is integrated into the motor or perhaps the wash/wipe sweep timer relay. It depends on how it is wired but unplugging the relay might stop them or it might not and even if it does it isn't likely to prove anything. Substituting a known good relay is the best way of testing and if that makes no difference I suggest checking the motor self-park switch next.

amp has no de thump circit in it or remote turn on not correctly wired

Thinking its your. Instrument panel switch. Common ford mustang problem dating back to my 1987. The switch go out and you're in the dark on the fox-body cars same identical issue I had about 3 years back. I purchased a replacement @ Latemodel Resto which I will tell you..... are not cheap..... ANYWHERE.... believe me I looked because forking out that kind of dough for something Ford should be replacing for its customers IE faulty OEM Part. Otherwise always check your fuses and relays first.

Can you have someone listen down by the starter when you turn the key to start to see if they can hear anything that sounds like a wrrrr ?

pulling the fuse o he ABs should turn off h light, but rcommend oing hat you need to find out wy te ab slight oN you need to have it properly diagnosed and fixed it might be as simple sreplacing a wheel speed sensor

No -- it locks the pulley mount against the mounting bracket. Loosening it off will release the pulley shaft and allow you turn the adjuster bolt .

1999 3.8l Ford Mustang fuse box diagram

StartMyCar https://www.startmycar.com > Mustang > Fuse box 1999 3.8l Ford Mustang fuse box diagram. The 1999 3.8l Ford Mustang has 2 different fuse boxes: Passenger compartment fuse panel diagram.

1999 4.6l Ford Mustang fuse box diagram

StartMyCar https://www.startmycar.com > Mustang > Fuse box 1999 4.6l Ford Mustang fuse box diagram. The 1999 4.6l Ford Mustang has 2 different fuse boxes: Passenger compartment fuse panel diagram.

Mustang, Fuse box, Diagram - Pinterest

Pinterest https://www.pinterest.com > Explore Dec 5, 2016 - Dec 5, 2016 - These Mustang fuse diagram are for a 1999, 2000, 2001, 2002, 2003, and 2004 Ford Mustang under the hood in the engine bay, . ..

Question edited for clarity and add maker. Question moved to model category.

Tilt away steering problem - MustangForums.com

MustangForums https://mustangforums.com > classic-mustangs-tech Feb 26, 2017 - Check for worn or broken vacuum lines running to or from the switch. There should be a vacuum canister that the lines connect to. Depending on ...

1967 Tilt Steering Wheel

Ford Mustang Forum https://www.allfordmustangs.com > ... > Classic Tech Dec 17, 2005 - On the 67 cars the tilt steering wheel is a purely mechanical assembly.No wires, no fuses. If you look at the steering column where the turn ... '67 Steering questions ' Ford Mustang Forum Feb 12, 2014 1967 Coupe Steering Wheel won't fit column snuggly Aug 5, 2012 More results from www.allfordmustangs.com ..