20 Most Recent
2005 Chevrolet Blazer 4WD Questions & Answers
2005 Blazer key won't turn in the ignition
You may want to try to slightly push / pull your vehicle to take weight / tension off the transmission, which in turn will allow you to turn the steering wheel enough to see if the ignition switch can be turned.
I have a 2001 Chevy S10 Blazer 4x4. The transmission seems to pulsate under acceleration but if I press the gas a little more the motor revs but the transmission loses power badly. What could it be?
4wd , A/T box.
brake are bad,
and engine misfires.>
we SCAN the PCM for P3xx or P7xx codes misfire and A/T errors (never skip this !!!)
you do know any transmission brain (TCM will get confused if the engine is weak or misfires right, so engine is first to worry.
but you said engine REVS (rpm up high) and car is slow and or
transmission fails to up-shift, to 2nd in drive.??????
any tech in any shop sees the car, and scans it first.
and see OMG dead transmission speed sensors
or sees, gross misfire,
or must drive it first to see what is going on.
if up-shifts fail at the documented shift points the transmission is bad.
or just 1 sensor on it.
this is called DRIVE_ability issue that can only be solved by tech driving it and seeing it fail.
not the blind, not me,but the shift points are what matters.
and if the tech feels misfire or power loss even in 1st gear.
he knows the engine has a problem. (or even both)
2001 is old car, most cars this old have like 10 ignored problems in the wild.
classic that.
or bad spark plugs and bad speed sensor both, a wild guess and common for sure.
post VIN or the RPO code so we can decode drive-train there.
I have a 2000 Chevy Blazer 4.3 wont start just cranks. I replaced fuel filter, it has a new gas cap and reader and new crank sensor.
Is the engine light on? If so you can hook it to a computer, if there's an auto zone close to you they will do it for you free of charge. I also recommend, laying under the vehicle and banging on your fuel tank with a hammer while someone else is trying to start it. It sounds odd I know but I think it may be your fuel pump, if it starts while your banging on it then it 100% is your fuel pump!Just a side note, I also had a 2000 Blazer and this happened to me a lot! So I'm suggesting this from experience. Chevy blazers are known for this issue.
Headrest removal on 2006 chevy trailblazer
Ok.. This is for removing the backseat headrests on 06 trailblazer..
you gotts cut the material right under the rest , you can superglue it back later..then with a hook tool a pick you find the pins at the base of the rod and pull them out.. He didnt have to cut the material on the next headrest after finding where they were located.. Kinda alittle painintheass job. But goter done..
karen cline
I got a 96 blazer
probably the camshaft position sensor is faulty. scan the diagnostic trouble codes for more insight into the cause of the problem.
Truck will not shift into second gear
I would agree with that assumption. your vehicle starts in 1st automatically. the vehicle speed sensor (VSS) tells the ECM how fast your vehicle is travelling and initiates the shift patterns at certain speeds and rpm's.
What is the torque on a 92 blazer body bushing bolts
There is no replaceable fog lamp relay. It's built into the digital instrument panel junction box (IP) and switches power using an intelligent power switch (power transistor) that's soldered to the board.
When you turn on fog lamps the body control module sees the signal from the fog lamp switch. It sends a digital signal to the IP which tells the IPS to power the fog lights. You need to use a pro scan tool to see if the Body control module is receiving the fog lamp request and then see the IP is receiving the command to switch on fog lamps.
Not finding what you are looking for?