Top 20
2006 Chevrolet Aveo LS Questions & Answers
We replaced the alternator and the battery and the belt tensioner but charging system light still stays on
There are two things that generally cause a battery warning after an alternator replacement. The most common is a loose connection either with the control plug (aka “relay” plug-in), charging line connection, or the ground. The other is a blown fuse or defective connector or relay, which could have been broken or shorted when the alternator was installed or on the first start-up after its installation.
You can check that the alternator is supplying enough power by starting the car and disconnecting the battery. If the car dies, the alternator isn't working properly (or a wiring/relay/fuse issue).
How to change brake pads?
take a screw driver and depress the piston by prying the brake pad against the rotor. Then take the caliber off and replce pads , then simply re-do step and reassemble caliber.The only problem you may run into is the caliber has to be pushed and turned at the same time. if so you will need a special tool to do so.
P0122 and p1122 high idle problem
Both codes are for the throttle position sensor - - sometimes the computer is not getting any voltage from the sensor. Could be a sensor problem or a wiring or connector problem.
Not finding what you are looking for?