2008 Ford Focus - Answered Questions & Fixed issues


code for ford 6006 cdc v030929

2008 Ford Focus | Answered on May 09, 2019 | 1,335 views


For the airbag light situation to be resolved you need the airbag code to be deciphered from a scantool that can read airbag codes,,If the alternator has low output it would turn on also the ABS light,If the car was flooded it is posible that the control module did short out its location in in the center bottom console

2008 Ford Focus | Answered on Feb 12, 2019 | 880 views


they snap into place but should be ablt to get the spot mirror to replace

2008 Ford Focus | Answered on Nov 29, 2018 | 209 views


Regarding the door. Ford used to use a microswitch buried in the door catch to signal when the door was fully closed Maladjustment of the door and/or striker often caused the striker to become damaged resulting in the failure of the striker to fully enter the door catch and activate the microswitch. They might still use that system.

Regarding the TPS system, it would be advisable to ask your local Ford dealer for a second opinion and a price quotation to fix it. I suggest you tell them nothing about what the tyre shop suggested might be the cause.

2008 Ford Focus | Answered on Jul 08, 2017 | 218 views


If you have not performed any service, might be a good idea to replace the components that you have mentioned and check to see if the problems go away.

2008 Ford Focus | Answered on Jun 24, 2017 | 254 views


the car doesn't have any vibrations unless there is a problem
you can tell the accredited service center to run the fault codes and if nothing comes up walk away from the deal until the seller fixes the fault

2008 Ford Focus | Answered on Jun 03, 2017 | 420 views


The device is not compatible with the Ford electronics, simple as that. That is to say the system can't read the USB device.

2008 Ford Focus | Answered on Mar 30, 2017 | 68 views


How many miles on it? Coil-over-plugs and spark plugs may need changed. They can throw electrical interference which can put you in Fail-Safe mode. Happened to me.
If car has over 70K, change the Coil-over plugs and spark plugs. Don't forget to change a fuel filter every 30K also.

don-ohio (:^)

2008 Ford Focus | Answered on Mar 27, 2017 | 37 views


Does the right indicator on the dash flash faster then the left when on ? Bad bulb .

2008 Ford Focus | Answered on Jan 25, 2017 | 295 views


The light is on because something has malfunctioned in the transmission system, this can be a sensor or wiring or the transmission has a mechanical fault. The next step is to have a scanner hooked up and read the fault code that was set in the control modules memory when it turned on the warning light. This may require a trip to the local dealer.

2008 Ford Focus | Answered on Jan 06, 2017 | 97 views


Did you check the horn relay ?
Horn The horn system consists of the following components:
  • horn switch (part of the driver air bag module)
  • horn relay
  • horn(s)
  • clockspring
  • The horn system consists of a relay, the steering wheel switch and 2 horns. The horns receive voltage from the switched side of the relay. The horn relay is controlled on its ground side by the steering wheel switch or the generic electronic module (GEM).
    The horn relay is supplied with constant voltage from the battery junction box (BJB) on circuit 30-DA1 (RD).
    The horn switch shares the clockspring with the air bag circuits, although each of these systems work completely independent of each other.

    Inspection and Verification
    1. Verify the customer concern.
    1. Visually inspect for obvious signs of mechanical or electrical damage.


    Visual Inspection Chart Mechanical Electrical
    • Horn(s)
    • Horn switch
    • Battery junction box (BJB) fuse 7 (40A)
    • Central junction box (CJB) fuse 33 (20A)
    • Circuitry
    • Horn relay
    • Clockspring
    • Generic electronic module (GEM)
    • BJB
    • CJB

    1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    1. If the concern is not visually evident, verify the symptom and GO to Symptom Chart .
    Symptom Chart Condition Possible Sources Action
    • The horn is inoperative
    • Fuse(s)
    • Circuitry
    • Horn relay
    • Horn switch
    • Horn(s)
    • Central junction box (CJB)
    • Battery junction box (BJB)
    • Go To Pinpoint Test A .
    • The horn is always on
    • Circuitry
    • Horn relay
    • Horn switch
    • Generic electronic module (GEM)
    • Go To Pinpoint Test B .
VEHICLE RELAYS Operation Diagnosis

2008 Ford Focus | Answered on Nov 24, 2016 | 50 views


A little white/blue smoke at startup is usually an indication of valve seals leaking a little. If it's only at startup and goes away, it's not a big problem - keep an eye on the oil level in the crankcase (dipstick).

If it's dense white smoke, and continues for up to a minute or so (or longer), you may be getting coolant into the cylinders - head gasket or worse problems. If this is the case, you may want to have it checked for contamination of the coolant by exhaust products.

2008 Ford Focus | Answered on Sep 14, 2016 | 47 views


Up inside right front fender , take inner plastic fender off . It's on top of the accumulator , round cylinder looking thing !

2008 Ford Focus | Answered on Sep 01, 2016 | 176 views


Dealer only ! unless you have the ford IDS factory scan tool !

2008 Ford Focus | Answered on Apr 05, 2016 | 39 views


U replace it with a new thermostat that will open and close per conditions.

Leaving old one in will not damage the engine - only thing is that it will take the engine longer to heat up. Up North you might just want some heat asap. But down south it is no big deal other than you are operating your engine for a longer period of time at cooler temps when it is less efficient.

2008 Ford Focus | Answered on Mar 04, 2016 | 181 views


run the fault codes and look for a problem throttle position sensor or throttle actuator motor fault

2008 Ford Focus | Answered on Feb 24, 2016 | 142 views


Hi Rico

You need to contact your Ford Dealership Service Dept

2008 Ford Focus | Answered on Nov 30, 2015 | 124 views


Restricted air flow. Replace the air filter if dirty. Clean the throttle body and MAF sensor. I use brake clean. Use a tooth brush on the throttle body , just spray down the MAF sensor. Leave the MAF off, start the car and spray some in the throttle as you rev it up. If the engine light comes on, it is because of the MAF being off. It will go out in a day or two. Or you can have it cleared.

2008 Ford Focus | Answered on Nov 28, 2015 | 97 views


State your vehicle, so we have some clue as to what your referring to!!!

2008 Ford Focus | Answered on Oct 26, 2015 | 68 views


sounds like blower switch

2008 Ford Focus | Answered on Oct 21, 2015 | 76 views

Not finding what you are looking for?
2008 Ford Focus Logo

376 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,703 Questions

2001 Ford Focus
2001 Ford Focus

2,580 Questions

2003 Ford Focus
2003 Ford Focus

2,002 Questions

2005 Ford Focus
2005 Ford Focus

1,196 Questions

2004 Ford Focus
2004 Ford Focus

881 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...