20 Most Recent 2009 Jeep Wrangler Questions & Answers


I think you could use this manual method instead..
My nephew use it to repair my car and it's totally perfectly fine now. Here's the website he bought it from. www.reliable-store.com

2009 Jeep... | Answered on Mar 07, 2018


Have you confirmed the alignment of the lead/end part of the open-side of the zip, with the closed/slider side.?
Getting the first bit aligned properly it vital.
Whether it's a metal or nylon zip, a bit of lubricating spray will help get the two sides going.
You may need to get a hairdryer (or heat gun if you're very, very careful) to warm-up the cover to allow it to stretch into position, if it's gone stiff in the garage whilst you've not been using it.?
Don't force it, ease it.
Forcing the zipper is likely to tear the stitching &/or the vinyl.
Best of luck.

2009 Jeep... | Answered on Mar 07, 2018


If the door is slightly ajar it will beep once and not start.

It is not likely a program problem. It is likely a door ajar or tailgate open etc.

the car first locks prior to starting. If the car cannot secure the doors etc it will only beep and flash once.

Check the lock the car function and confirm it is operating.

Hope this helps? 2012 Jeep Wrangler Factory Remote Start

2009 Jeep... | Answered on Feb 01, 2017


JK jeep, i have 08 and full docs.
it wires to the PCM, same wire colors
as you can see drawing dont work right in fixya.
they get "crunched" badly"
the EGR is PWM modulated,
first is to clean in. the exhaust path must be good
the EGR must not stick closed or open.
p0405 means the pin on sensor part is stuck low.
tell me in most cases, the valve is stuck closed.
clean it is best first action.



26404471-dlj153dynqe1qkaeryvrbplc-3-0.jpg

26404471-dlj153dynqe1qkaeryvrbplc-3-1.jpg
the monitor pin is at X, this tells the PCM where the EGR moved
per PCM command. (called feedback) yours is hard stuck.
26404471-dlj153dynqe1qkaeryvrbplc-3-3.jpg

2009 Jeep... | Answered on Dec 19, 2016


Sounds like a safety feature alerting you or pedestrians of you going in reverse.

2009 Jeep... | Answered on Feb 04, 2016


nice double post. and answered.
its a cable.
i bet its good, and are driving on dry pavement (wrong)
am i right?
read the manual yet?
its part time 4wd

2009 Jeep... | Answered on Mar 17, 2015


that is called the FSM
the OEM factory service manual.
09 JK , i have 08.
what transmission, is there A/T or m/t stick>??

alldata.com has this
as does tech authority. (FSM source real)
if doing work DIY buy the book first, the read it and ask questions?

is this your first cable? ever?
not even ever fixed a bicycle cable.???

the shifter lever goes to a thing called, the transfer case
i hope you read the operators guide first, and not driving on dry ice free pavement, as that is wrong, so dont blame shifter on your not reading the book.
why not post symptoms first, the your guess. be best huh?
but ill play this game, you asked how, so will tell.

did you scan it first to see if you have C14xx errors.?

jack up car, yet, and have person 1 move lever and person2
look at the transfer case end. to see if the cable even works in
its full range, (1:1 ACTION) ?
IF IT DOES, you are barking up wrong tree.

to remove cable page 7167
1. Shift transfer case into 4L.
2. Raise vehicle.
3. Remove clip securing the transfer case shift cable (2) to the shift cable support bracket.
4. Disengage any additional shift cable routing clips, if necessary.
5. Disengage the shift cable from the transfer case manual lever.
Fig. 111: Shift Lever

6. Lower the vehicle.


but only if its bad. if it moves full range , wheels off ground, its good.






25582981-gqg4vgattcy132cyk4df3qpe-1-1.jpg

2009 Jeep... | Answered on Mar 17, 2015


what country is this car.?
USA< or export.

is this car a JK wrangler car.

here is liberty.

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=35702


ever google, ? here ill type for you, and magic happens......

https://www.google.com/webhp?gws_rd=ssl#q=jeep+crd+fuel+filter+replacement

2009 Jeep... | Answered on Mar 04, 2015


Unhook the battery for a while to give the computer time to reset, maybe as much as 24 hours then try it again. Could be as simple as a bad seal on the gas cap.

2009 Jeep... | Answered on Oct 28, 2014


well does your state have the lemon law. in illinois there is a law that states if you bring a vehicle back three or more times and it can't be fixed you are untitled to a new car.

otherwise check the sway bar link pins they can be at fault.

2009 Jeep... | Answered on Oct 07, 2014


which engine???? , option we can not guess.?????
but is of no matter, the ECU sets this order. not YOU.
but lets ask this a different why
my V6 has a coil pack with wires.
how are those set.? wasted spark systems.... vary by engine.
on mine this way. 3.8L 2008 wrangler.
nice drawing ,no? better than FSM pages.

http://www.fixkick.com/Jeeps/ASD.html#coil-pack

2009 Jeep... | Answered on Sep 07, 2014


Because when you start it the brake booster will start working, start bleed on wheel farthest from master cylinder and work closer, one at a time pump up and bleed each line at least once after you don't see air anymore...

2009 Jeep... | Answered on Jul 22, 2014


bad linkage. jeep can sell you the parts that are worn.
while looking at the shift linkage, and shifting it, see what part is loose.
easy ,huh?

http://www.factorychryslerparts.com/showAssembly.aspx?ukey_assembly=711777&ukey_make=1064&ukey_model=15533&modelYear=2009&ukey_category=20318&ukey_driveLine=7576&ukey_trimLevel=18840&searchString=shift

i guessed at car trans and options, so... pick better.

2009 Jeep... | Answered on Apr 17, 2014


You need the system scanned by the dealer for stored fault codes.

2009 Jeep... | Answered on Apr 12, 2014


which fans, there are up to 4 fans
1 condenser.
2: radiator can have 1 or 2.
3: heater blower. fan.

what is normal operation.?????

my guess is this is and HVAC question.
but what works and what don't
are you heating car.
cooling car
or running front defrost that fails.

all 3 are normal.

2009 Jeep... | Answered on Apr 01, 2014


It either the ground strap ends for the alternator need to be cleaned or replace if missing or the alternator need to be tested and replaced if defected. China OBD2 car diagnostic tools wholesale on CareUCar

2009 Jeep... | Answered on Feb 12, 2014

Not finding what you are looking for?
2009 Jeep Wrangler Logo

Popular Tags

106 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Wrangler Jeep

  • Wrangler Jeep

Most Popular Question

my2009 jeep wrangler when put in

  • Cars & Trucks
Loading...