20 Most Recent 2010 Chevrolet Camaro Questions & Answers

It only has two wires to it. It still works if you hook it backwards.

To bypass the anti-theft system, unlock the driver's side door with the key and leave in the open position for at least 20 to 30 seconds; this helps the system identify that you have the right key. If this does not work-simply, turn the key back and forth a couple of times when inserted in the door.

Something is going on with your electronic brake control module (EBCM) which is delivering "rough road" data to the ECM. This could be a faulty sensor in the system, but I suggest you have the EBCM checked by a dealer.

On the 2010 Chevy Camaro V6, that vent solenoid is on top of the rear cross member. You might be able to squeeze a VERY small hand in there, but the regular service procedure is to drop the cross member down. Sucks, as I just had to replace the same valve.

Your owners manual says, 18.8 gal Does that sound about right?

My 2010 Camaro is doing the exact same thing... Did you get your fixed?

more details as to the clutch operation is it hydraulic or cable operation what do you mean cannot get clutch to engage can you get gears with out slashing them,

Just follow the top radiator hose Dedric.

Hi Brad, Did your windshield Fog up immediately when you switched to defrost? Can you also feel air coming from the vents at the top in defrost mode? If so, Could be your heater core is leaking.....If not I'm going to need some more information. Hope this helps, Good Luck, Randy. I’m happy to assist further over the phone at https://www.6ya.com/expert/randall_d932ef6e01588b0f

RockAuto Parts Catalog

Connecting Rod bearing cap bolts torque to 27N~m (20 lb. ft) + 50 degrees with torque angle gauge. You my also find this web site useful. www.mifbody.com There is a bulletin for this procedure.Hope this helps, Good Luck,Randy. I’m happy to assist further over the phone at https://www.6ya.com/expert/randall_d932ef6e01588b0f

http://www.carcarekiosk.com/video/2010_Chevrolet_Camaro_SS_6.2L_V8/belt/check

The mounting screws are accessible from the trunk.

If your talking about the evos system,,, be located on or near gas tank,, usualy under the car over the rear axle,, square looking black plastic box with the valve bolted on the side, wires coming out,,and 2/3 rubber vent lines also could be in the trunk mounted behind the left or right fender panels,,, if its throwing a code for bad valve and the engine light is on i would also have the gas cap checked or try replacing it first,,,, it will make it do the same thing,, bad gas cap could be your problem and its cheap been there done that tater