Ford Cars & Trucks - Page 6 - Recent Questions, Troubleshooting & Support
My ford figo petrol indicators are not working
I suggest you take your car to a certified Ford mechanic to diagnose the issue. In the meantime, here are some possible causes of the problem:
Blown fuse: Check the fuse box and replace any blown fuses .
Faulty flasher relay: A faulty flasher relay can cause the indicators to stop working. A mechanic can replace the relay if necessary.
Bad bulb: Check the bulbs and replace any that are burnt out or damaged .
Defective connector: Check the connectors between the flasher and the switch. If they are defective, they may need to be replaced.
I have no power to the fuel pump and dont know what to check on a 89 Ford bronco ll
Check the fuel pump relay switch. According to a post on the Ford Truck Enthusiasts Forums, the fuel pump relay switch is located under the PDB (Power Distribution Box) . You may need to refer to the wiring diagram to locate it. If you don't have one, you can request it from the same post.
Check the fuel pump cutoff switch. This switch is located behind the firewall and is designed to shut off the fuel supply in case of an accident .
Check the fuel rail pressure regulator. If the fuel pump and the fuel cutoff switch are working fine, then the problem might be with the fuel rail pressure regulator. This is a small can mounted inline with the fuel rail with a vacuum hose attached to a hose barb on top of the unit .
Firing order for a ford f-150 4.2
For the 1997 Ford 4.2L V-6:
Firing Order:
1-4-2-5-3-6
Cylinders:
(back of engine)
3-----------6
2-----------5
1-----------4
(front of engine)
Let me know if this helped...
P0344 Camshaft Position Sensor A Circuit Intermittent (Bank 1 or
The camshaft sensor is located right above the crankshaft pulley on the passengers side of the front cover of the engine. It will be a 3 pin sensor either gray or black in color. There is a pointer that is attached to the sensor and it is either gold or silver in color. There is also a recall out on this camshaft sensor. If the color of the sensor is black then it should qualify for the recall. If you get in touch with a Ford dealer they should be able to help you with your recall if the sensor is black since it is a safety recall. As far as your exhaust pressure sensor it is located on the front of the engine right by the heater core hose a little to the passengers side of the center of the front of the engine. there will be a tube attached to the bottom of the sensor that goes from it to the front of the exhaust manifold on the very front of the passengers side exhaust manifold.
2008 Ford Fusion. Where is Shift Solenoid F on it please?
So there are multiple transmission types that could be in your vehicle depending on what engine you have. The 4 cyl would have a FNR5 transmission - A 5 speed automatic from Mazda and the V6 would use the Aisin
AWF-21 6-speed.
To access
the SSF on the FNR5 you need to remove the side cover located on the back for the transmission by the firewall. The are 2 solenoids located under this cover and the SSF will be the smaller of the 2 and should have a normal Ohms reading of 8.4-21.8 Ohms when testing.
The AWF-21 does not have a SSF so I don't believe this is the transmission you have but if it is let me know and I can try to figure out what solenoid you might be looking for.
Not finding what you are looking for?