Chevrolet Impala - Recent Questions, Troubleshooting & Support - Page 3
2005 Chevy Impala 3.4 V6. Why is it stuck in drive?
Question edited for clarity.Question moved to model category.Wow, that is cold for Texas. It probably has the original transmission fluid in and it is gummy and thick. The filter is probably blocked because of the cold and the shift solenoids are also sticking because of the temperature. Start the vehicle and let it tick over until it gets to normal operating temperature, then try again. Get to a transmission shop and have the transmission filter cleaned and new transmission fluid.
2007 Chevy Impala, clicking noise starts BEFORE key in ignition. Why?
If your 2007 Chevy Impala is making a clicking noise before the key is even inserted into the ignition, it could be caused by a few different issues. Some potential causes include:
- Faulty starter motor: The starter motor is responsible for starting the engine when the ignition is turned on. If the starter motor is faulty or has worn out, it may make a clicking noise as it tries to engage with the flywheel.
- Loose or damaged starter motor relay: The starter motor relay is an electrical component that sends power to the starter motor when the ignition is turned on. If the relay is loose or damaged, it may cause a clicking noise.
- Low battery: If the battery is low on charge or has gone bad, it may not have enough power to start the engine, causing a clicking noise.
- Other electrical issues: There may be other electrical issues, such as a loose connection or a problem with the ignition switch, that are causing the clicking noise.
To determine the cause of the clicking noise, it is recommended to bring your vehicle to a mechanic or a dealership for further diagnosis and repair. They will be able to test the starter motor, battery, and other electrical components to determine the source of the problem and recommend the appropriate repairs.
Cause for low oil pressure warning in 2006 Impala?
God so many of these people that try to add their Solutions are beyond ridiculous if you DO NOT KNOW WHAT YOU ARE TALKING ABOUT DO NOT SUPPLY A SOLUTION. Great thanks to A Miller for providing a correct answer to the guys problem. If you are getting this light Oil Pressure Low Shut Off Engine it IS NOT BECAUSE you need to press the accelerator 3 times to reset the OIL CHANGE LIGHT. the OIL CHANGE LIGHT and the STOP ENGINE OIL PRESSURE LOW Light are two COMPLETELY DIFFERENT LIGHTS....
Can you fold down rear seat on 2007 chevy malibu
To fold-down rear seat on 2007 Chevy Malibu, follow these steps:
1. Open the trunk
2. Pull on one or both the handles located on the upper side of the trunk
3. The handle located on the driver's side will unlatch the bigger part of the read seat
4. The handle on the passenger side will fold down the smaller portion of the rear seat.
5. Once done, you will have a seat that's nicely folded down.
Soft plug at the back of the engine is leaking,
you engine has about 10 freeze plugs,there were created to be pushed out by ice if your antifreeze wasn't strong enough and froze inside the engine,that way the ice didn't crack the block when it expanded.
what causes freeze plugs to leak is the erosion affects from the antifreeze we use today,when they tell you to change your antifreeze every couple of years,the freeze plugs take another shot of strong antifreeze again,they just rust up on the inside of the engine until they get a rust hole in them
My 03 impala instrument lights
Hello,
Thanks for using FixYa.
You have a busted dimmer switch control module. Just bring your car to the dealership and have them fix it. It will be cheap to have that fixed. Its a simple switch replacement job.
- HotRatchet
Engine light stays o n my 2006 impala
you may have to reset the engine light. These cars are all computerized. Call the dealership and tell them that you had to replace the gas cap as it was faulty and caused your check engine light to come on. Ask them if they can reset the "computer" or if they can tell you how to do it (if that is possible).
Don't know if that will work, but my dad has been in the car business for over 35 years - I tend to listen to most the things he says......
Where is camshaft sensor in 2007chevy impala 3.5
camshaft position sensor is located at front of the engine- center of engine block above timing cover....three wires( red- brown with white - black.).....the camshaft actuator is located at the right of timing cover two wires ( brown-tan )
Not finding what you are looking for?