Chevrolet Impala - Recent Questions, Troubleshooting & Support


CAL stands for Calibrate. The IPC (instrument panel cluster) needs to be recalibrated. This could becaused by a battery/power spike, which means the IPC will need to relearn default settings, or therecould be an underlying problem. Technician will need to hook it up to a computer to analyze problem,and relearn settings.

2006 Chevrolet... | Answered 10 hours ago


When you have air in your cooling system, check for leaking gaskets. Most of the time the head gasket is leaking. and it is just a matter of time the whole gasket blows out. It will cost you because the engine needs revision, once the head gasket blows. Don't drive till a tech has checked your engine.

2004 Chevrolet... | Answered 2 days ago


The obvious problem is it is not the correct one. Carefully compare the old one with the new one - if not the same, take the old one back to where you purchased the new one and get the correct one.

2003 Chevrolet... | Answered on Nov 03, 2019


It is possible that it could be the key switch. Some connections or wiring might be lose in that area. Other than that it could be the wiring for the dashboard that could be loose. Loose wiring or loose ground may also cause this making it look like as if the power supplied by the battery is not enough. I would also check the dimming switch. It may also be loose or is going bad.

2004 Chevrolet... | Answered on Nov 01, 2019


TRY THIS!
30-MINUTE LEARN PROCEDURE
1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON, vehicle will not start.
3. Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
4. Turn OFF the ignition, and wait 5 seconds.
5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
6. Start the engine. The vehicle has now learned the Passlock(TM) Sensor Data Code and/or password.

IMPORTANT: The vehicle learns the Passlock(TM) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

2001 Chevrolet... | Answered on Oct 28, 2019


It is possible you have a poor radio connection, if you are trying to listen to radio. You can try to straighten your antenna or free it if it is tucked under a windshield.

Chevrolet Impala... | Answered on Oct 25, 2019


located near the back of the engine block, on the passenger side. Near the starter.

2008 Chevrolet... | Answered on Oct 12, 2019


Make sure it's all the way in "park", and try wiggling the steering wheel while you turn the key. Pretty new car to have problems like that.

2008 Chevrolet... | Answered on Oct 11, 2019


Only if you go to the dealership. I suggest if you own this car and plan on keeping it for a bit get your self Chilton Repair manual and Haynes repair manual. You can at least be familiar with what and how somethings repaired so you could avoid a costly repair. If a mechanic sense you dont know much about cars watch out. These manual have wiring schematics and diagrams indicating where fuses and relas are located. The manuals are vehicle specific so youd ask for Chevy 2010 Chevrolet Impala. Having some knowledge is better than none and no it's not an expensive repair if you are doing it yourself.

2010 Chevrolet... | Answered on Oct 09, 2019


gee not codes to read
leaves you with ECU or a module fault
fuel pump or fuel pump relay
bad fuel
while hot.. coils packs or crank angle sensor might be worth testing

2003 Chevrolet... | Answered on Oct 04, 2019


Probably bad spark plugs, wires or ignition coil. Also cylinder number one spark plug is prone to cracking. If you cant isolate a cylinder pull each plug out and inspect for carbon tracking or plugs worn. Recommend using AC Delco original equipment replacement spark plugs.

2005 Chevrolet... | Answered on Oct 04, 2019


Left side of engine near starter.

2003 Chevrolet... | Answered on Oct 03, 2019


You cannot easily move the seat. There are gears on both tracks that are turned by cables. May need to replace the complete seat frame, I don't think the parts are serviced separately.

Chevrolet Impala... | Answered on Sep 29, 2019


Chevy has 3 different antitheft systems. What year is your Impala?

Chevrolet Impala... | Answered on Sep 25, 2019


Check the throttle body position sensor make sure its plunged in switch my be faulty.Unplug and see if car will start if so replace sensor .

2013 Chevrolet... | Answered on Sep 19, 2019


The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com

Chevrolet Impala... | Answered on Sep 19, 2019


What heating and cooling sensor are you talking about? I've never heard of one, clicking sounds like a relay. Please explain better what your talking about please.

2011 Chevrolet... | Answered on Sep 16, 2019


this is a VERY good engine to own!!! you shouldnt have to replace te water pump unless it goes out,and the timing belt ,on ANY engine ,should be replaced at factory recommended intervals. the mileage on this car is below average. I love this engine...good power,reliable ,easy to work on,and parts are relatively inexpensive.

2004 Chevrolet... | Answered on Sep 16, 2019

Not finding what you are looking for?

-9,123 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Chevrolet Cars & Trucks

  • Forum

View Most Popular

  • Chevrolet Cars & Trucks
Loading...