Acura Cars & Trucks - Popular Questions, Answers, Tips & Manuals

Question edited for clarity. Question moved to model category. No, it is no a replaceable item and is located in the bottom of the fuel tank and is part of the fuel pump Attached to the fuel pump in the gas tank. It's not a replaceable part. You would have to replace the pump in the tank. Actually it is replaceable, but not a maintenance item. Apr 12, 2011

fuel filter location on 01 CL ? - Acura Enthusiast Community

AcuraZine https://acurazine.com > ... > 2G CL Problems & Fixes ..

Here are the instructions to test the braking switch and related components to locate the fault. Brake Pedal Position Switch Test 1.) Disconnect the 4P connector from the switch (A). 2.) Remove the brake pedal position switch. 3.) Check for continuity between the terminals according to the table, using a multimeter. 4.) If the continuity is not as specified, replace the brake pedal position switch and adjust the pedal height. 5.) If OK, install the brake pedal position switch and adjust the pedal height.

Question edited for clarity and make sentences.Remove the unit, remove the connectors, spray them with electrical contact cleaner and then replace them making sure they are well locked into place.Or there is a dry joint inside the unit.Start with the easy stuff first.https://www.google.com/search?q=Acura+RLX+radio+turns+off+every+time+I+hit+a+bump..

Unlikely :>D https://www.google.com/search?q=2006+Acura+MDX+navigation+system+code+for+free ..

Question edited for clarity. Question moved to model category. Duplicate deleted, just Refresh page to see your question.

P1607 Acura Code Meaning, Causes, Symptoms, & Tech ...

Engine-Codes.com https://www.engine-codes.com > p1607_acura The Diagnostic Trouble Code (DTC) will set when the Powertrain Control Module detects an internal circuit failure.

I have a 2002 Acura 3.2TL Type S. It is giving me a code of ...

JustAnswer https://www.justanswer.com > Acura Repair Nov 30, 2010 - I have a 2002 Acura 3.2TL Type S. It is giving me a code of P1607, which is for an internal error in the Powertrain Control Module. 1 answer · Top answer: Hello, this isn't much more option to this code but a faulty pcm. You can try and find a ...

Code P1607 Acura Powertrain Control Module Internal ...

AutoCodes https://www.autocodes.com > p1607_acura The Diagnostic Trouble Code (DTC) will set when the Powertrain Control Module detects an internal circuit failure. OBDII Code P1607 Acura - Powertrain Control ... ..

So no crank, (the engine doesn't turn) and no start? Did you disconnect the battery during the starter install? Did you reset the anti theft immobilizer afterwards? https://www.google.com/search?q=2003+Acura+MDX+no+crank+no+start ..

Sure you can drive it. Only problem is the radio may have a security code if you pull the fuze you'll need the code...it should come w/ the owners manual.... if not then you gotta take out the deck and there should be a serial number behind the deck which will tell you the code for the deck. Or the dealer can help with the vin and a ID that you own the car. Best to you.

Unhook the negative post of the battery for a minute and that should reset the computer.

need to remove the door panel ---if chid lock was on would be able to open using outer handle most likely linkage or clip fail

https://www.google.com/search?q=1999+Acura+CL+TCM+Location ..

Check for spark to the plugs and fuel to the injectors. A scanner would help to find a problem. First start by spraying a little starting fluid into the throttle body. If it starts, then check fuel pressure. You may have a bad pump or relay. If no spark, problem could be a bad sensor or bad connection to a module.

Question edited for clarity and toss in some CAPS. Question moved to model category. When you replaced the fuel pump, you disconnected the battery, yes (because they tell you to)? You now need to reset the security system and engine immobilizer.

How do i reset the Acura immobilizer?

Vehicle History https://www.vehiclehistory.com > questions > how-do-... To reset the immobilizer on Your Acura, insert the ignition key in the driver-side door lock. Turn the key to the unlock position. Turn the key to the lock ... ..

You have done well so far, but what if both relays have failed or one is working and the other is stuck closed with burned contacts? For a hundred dollars, you could get it diagnosed and fixed professionally by someone with the equipment and the ability to access and understand wiring diagrams. Relays and switches can be tested very easily. You have the added problem that the BCM is involved in lighting. https://www.google.com/search?q=auto+electrician+near+me ..

Sadly, for a vehicle of this vintage, even a locksmith would have to call the company, probably pay a fee which he would pass along, just to get the "pin" for the vehicle. Using a locksmith to do this is very likely considerably cheaper than having a dealer do such. That's my experience.regarding even a 2007 vehicle.

Question edited to add maker. Question moved to model category. Here is one idea and some videos. https://www.justanswer.com/acura/6uky3-acura-mdx-low-beam-headlights-will-not-on.html

ck here.... https://duckduckgo.com/?t=ffab&q=+remove+the+wiring+from+the+rear+view+mirror+in+a+04+Acura+TL&atb=v159-1&ia=web

the car needs service. takes tools to diagnose no starts. lots all fuses good.? will it start with 5%(at tad) right foot depressed? on throttle. IMMO lamp glowing on the dash and ignored? immoblizer. lamp in the cluster. per the users guide (lost)>? there are up to 50 causes. check for spark?

More information please. What exactly do you mean by "smoked some"? How heavy was the smoke, was it thicker and heavier than normal? Did it have colour to it like a dense white or a blue tint? This information gives clues to the problem. The engine spinning but not starting is commonly a 'No spark' issue but if you can get it to run some of the time it could be a faulty sensor. Do you have any warning lights on the dash? It could be worth you getting it scanned with an OBD2 scanner to look for trouble codes. These give clues to any faulty sensors. If you have to pay for this service ask at 4 or 5 places as prices can be VERY different. Why do you need access to the fuses under the stereo? These are not normally a common set of fuses that cause issues. The fuse panels most commonly used in an MDX are under the hood, left side trim panel (nearest the door hinge) in the driver's footwell and in the left side trim panel in the truck.