- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
MFG Supplyhttps://www.mfgsupply.com > shi0206
OEM Replacement This part is aftermarket equipment designed to replace the original manufacturer's part numbers specified here. ... 2014 Polaris Ranger Diesel.
US$162.33
It's not about the sensor. Overheating of the engine and the formation of gas bubbles during operation of the engine in the expansion tank must be replaced with a gasket of the cylinder block
hi.
this is all i can find on the internet about it. Where to find serial number on Polaris Ranger?
Whenever corresponding about a Polaris RANGER utility vehicle, be sure to refer to the vehicle identification number (VIN) and the engine model number and serial number. The VIN can be found stamped on the lower frame rail on the front LH side of the vehicle (see Figure 1-1).
Yes, it will start but it has a tendency to drain the battery. I had the same issue with mine and the dealership couldn't find the problem. I had a buddy verify the drain via electronic troubleshooter. I replaced the regulator and haven't had any problems since then.
The most common causes of a water cooled engine overheating are (1) poor circulation of cooling fluid (bad water pump or stopped up radiator); or (2) inadequate air flow cooling (bad cooling fan); or (3) compression gases entering the cooling system (leaking head gasket or cracked block or head). The first check is to see if air is in the cooling fluid (small bubbles appearing in top of radiator or coolant reserve tank). If so, then #3 is the problem. The second check is to see if the cooling fan (s) is running properly (can feel air flow on output side?). If not check wiring and/or replace fan (#2). The last step is to drain the radiator and engine (turn over engine to allow water pump to empty the block). If additional cooling fluid does not drain out the radiator drain port, the water pump is defective. If the water pump does empty the block, then flush the system with a good flushing agent. Follow instructions on flushing agent bottle. Drain out the flushing agent and re-fill radiator and block with clear water. Run engine as per instructions on flush agent bottle. Drain system again and re-fill with antifreeze (50%) and water (50%). If vehicle is located in a very cold climate, then increase the antifreeze % up to 75% (25% water). Remember, not only does antifreeze help to keep water from freezing, but it also helps to increase cooling ability.
×