LG Washing Machines - Recent Questions, Troubleshooting & Support


Pull the washer out and tilt it up against the wall. It is always better to look from underneath because the water leak travels downwards.

LG Washing... | Answered on Nov 03, 2019


You might try replacing the thermistor in the bottom of the outer tub. It's only a $6 part and pretty easy to do. Try cold only wash and see if it works. Also, try putting washer into test mode and run through each segment that it tests. Let us know results by commenting back pls

LG Washing... | Answered on Nov 01, 2019


These any good ? Direct from the LG site:

TV Dimensions with Stand (WxHxD)38.3" x 24.8" x 8.5"and TV Dimensions without Stand (WxHxD) 38.3" x 22.5" x 3.3"

Good luck.

LG Washing... | Answered on Oct 26, 2019


first check the lid switch. its a magnetic switch which tells the machine that the door is closed for it to start its operations. if that switch is OK then maybe your push in button needs replacing.

LG TROMM WM2688H... | Answered on Oct 23, 2019


I had this problem with another model LG washer dryer and the problem was just the tiny switch (6mm x 6mm) on the circuit board had worn out. They cost about 30 pence on eBay and are very easy to remove and re-solder onto the circuit board as there are only 2 pins. This saved a huge amount of money for a new control board.

LG WM-1832C... | Answered on Oct 23, 2019


Spray WD 40 and wipe clean with cloth, not leaving any fibres on the PCV board.

LG Washing... | Answered on Oct 22, 2019


There is also a discharge lint filter on the front lower left that has to seal properly. If the water appears only when washing, you can probably eliminate leaking from the water supply side up to the solenoids controlling the water. The most likely source is a leak in the rubber section between the tub and the front door, a leak in the seal between the door and the washer, a leak or overflow in the soap dispenser, or a leak in the discharge side components. You could probably figure out the source if you could view these areas during a cycle, but that would require some disassembly of the cabinet so that you would need to know what you were doing.

LG WM2101H Front... | Answered on Oct 17, 2019


LE is speed sensor error. Easy replacement. Check YouTube. Are you sure it isn't 'tE" error. Thermistor error. Very common. Videos also on repairclinic.com or appliancepartspros.com.

LG Washing... | Answered on Oct 16, 2019


It sounds like the suspension dampers need to be replaced. Lubricant wears away and when the plastic meet metal it will make those odd noises as tub sways to center itself. I recommend replacing all 4 suspension dampers.

LG Washing... | Answered on Oct 10, 2019


yes go to repair clinic.com type in model number and can get it there and its fast

LG Washing... | Answered on Oct 05, 2019


Check pump for restriction, undo cap at lower right hand side at the front and check for any foreign matter, make sure all water is out of the machine and put a towel on the floor

LG Washing... | Answered on Oct 01, 2019


Are you talking about one of the 7or 8 screws/bolts that hold the stator in place/ and one of them cannot be tightened to stay tight/

LG Washing... | Answered on Sep 30, 2019

Not finding what you are looking for?
LG Logo

Family Lines

11,861 questions posted

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...