Frigidaire Refrigerators - Recent Questions, Troubleshooting & Support


If new and under warranty contact supplier. If you attempt to fix while under warranty and cause further faults then you may void warranty.

Frigidaire... | Answered on Oct 03, 2019


Hi- not sure if it will help but I had issues getting it out. What I found is the plastic casing (fridge) needed a little twist/push. Play with it- hold the filter in and GENTLY push/pull/twist slightly the fridge housing.

Frigidaire... | Answered on Sep 29, 2019


I would say that either the filter has split or the seal where it screws into the housing has failed. I would try a new filter and seal.

Frigidaire... | Answered on Sep 23, 2019


Unplug your refrigerator from the ac outlet, and 0open theref door for approx. 5 minutes. Then plug it again, after you hear the beeping close the door. wallah it's fixed.

Frigidaire... | Answered on Sep 18, 2019


There is a little bar that is on the ice bucket. That bar has to go into the middle of the plastic square that is on the back wall of the freezer. Try Pulling out the ice bucket, get a hair dryer and run the hair dryer on the back wall of the freezer right above the hole where that little bar goes. After you run the hair dryer for about 10 minutes or so put your finger in the hole and pull down on the plastic square. Make sure when you put the ice bucket back in the freezer, the bar goes inside the square hole, not under it, not over it. In it. If that doesn't fix the problem you probably just need a new solenoid. Part number 5304404333

Let me know how you make out. Good Luck

Bill

Frigidaire... | Answered on Sep 16, 2019


There are a number of reasons why this might be happening. You bets bet if to call a service guy out and let them take a look at it as some things require specialised equipment to troubleshoot.

Frigidaire... | Answered on Sep 14, 2019


We had the same issue. My husband unscrewed the filter cover (1 screw on the left side of the filter under the light flap). Then he pushed the old filter in & lifted it up and it came right out.

Frigidaire... | Answered on Aug 29, 2019


possible bad water solenoid on bottom in back

Frigidaire... | Answered on Aug 22, 2019


The only access to the drain tube is from the inside which would mean removing the inner cabinet or liner - completely impractical and probably a waste of time as a collapsed drain tube is likely to be a sign the insulation is failing.

I expect you will find there will be at least one cold spot on the outer cabinet. A friend had the same trouble. In her case the top at the back was the worst offender and we extended the life by placing a 4" polystyrene block on the top. She mopped out the fridge daily.

I find a curtain wire is the most suitable for poking around in fridge drains.

Frigidaire... | Answered on Aug 22, 2019


There is an opening next to the auger that dispenses the ice.  In there there is a lever that must move up and down. It actually seats the metal rod on the bottom of the ice maker and controls cube or crushed.  Make sure the lever is down (cube position) when you return the basket to the freezer. I had to hold it down while I slid the rod into the opening. Viola! Cubes again. http://www.applianceblog.com/mainforums/showthread.php?t=783
check it out!  Thanks to Jake!

Frigidaire... | Answered on Aug 13, 2019


The refrigerator needs to be perfectly leveled side to side dn should pitch back slightly. Also look at the plane of the doors, that is to say that they should be squared to the cabinet. If they are sagging, you may need to adjust the hinges.

Frigidaire... | Answered on Aug 10, 2019

Not finding what you are looking for?
Frigidaire Logo

8,666 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a Frigidaire Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...