Refrigerators - Page 8 - Recent Questions, Troubleshooting & Support


Hi- not sure if it will help but I had issues getting it out. What I found is the plastic casing (fridge) needed a little twist/push. Play with it- hold the filter in and GENTLY push/pull/twist slightly the fridge housing.

Frigidaire... | Answered on Sep 29, 2019


My sympathy. You are having a bad day.
The most likely cause is your defrost evaporation pan (if the refrigerator is frost free and almost all within the last 20 years are) the defroster runs water from the freezer unit (and maybe refrigerator unit) down a tube to a pan under the machine.
You will need to pull the machine out where you can get all around it, find the pan, pull it out (may have water in it) empty the pan, clean the pan (if you have had the machine long, it may be nasty), and then make sure that the tube is clear. Sometimes the part that goes from the tube to the freezer and or refrigerator compartment is tilted down so the water goes into the machine instead of down the tube.

You also need to clean the coils and other parts of the underneath of the refrigerator while you are there.

If this does not fix the problem, you probably need to pay for a service call. Sears is always sending me e-mails telling me how cheap their service is. You may want to check it out before your start as they may give you a "special introductory offer".

Panasonic... | Answered on Sep 29, 2019


I had the same problem. The cause is the digital display is not communicating with the motherboard. What had happened in my case is the plug connection between the door's digital display and the motherboard had become unplugged. The wire running from the motherboard runs below the fridge, and connects via plug located along the bottom of the fridge below the freezer door, connecting to the wire running from the display to the bottom of the freezer door. I just reconnected it and that reset the display. Glad for it too, I thought I needed a new $130 motherboard! Hope this helped!

GE Refrigerators | Answered on Sep 29, 2019


Is the door equipped with glass defrost? If so , the board is looking for the heater strip around edge of glass. This can be in the chain of the interlock. This precheck, done as soon as pwr is connected, is to protect the compressor and the board. If not,,, check light switch for open door. Look for disconnected wire , plug. All my best , Russ.

Refrigerators | Answered on Sep 28, 2019


if on auto it will work on electric if on LP or unplugged will work on LP

Refrigerators | Answered on Sep 28, 2019


I feel you need a repair man to look at it. If you play with it yourself it could cost you a lot of money.

Daewoo... | Answered on Sep 28, 2019


I just bought the SamsungRF267AB bottom freezer refrigerator.  Amoung the features that must be disabled for shabbos are the lights, motor cuttoff and inside panel indicators.  On most refrigerators there is a swich that you can tape in the depressed mode that will trick the unit into thinking the door is still closed.  With this unit it's magnetic.  you need to place a magnet on the top of the door frame to make the refigerator think the door is still closed.  I hope this helps.

KitchenAid... | Answered on Sep 27, 2019


The floor is not level and/or the wheels underneath are not locked or blocked.

Refrigerators | Answered on Sep 27, 2019


it could be your evaporator fan that's located in the back of your freezer being blocked by ice buildup. you will have to turn off the light by either using a magnet or pressing the light switch off so fan will run while door is open. Fan will not run while door is open and light on. Do you have frost buildup on rear wall of the freezer?

LG Refrigerators | Answered on Sep 26, 2019


  • Refrigerator may not be level front to rear (possibly side to side)
  • Binding hinges due to misalignment
  • Not closing flush so the magnetic door seals work
  • Not sealing evenly due to misalignment
  • Weak magnetic door seals (due to age)

Liebherr... | Answered on Sep 26, 2019


Hi, on one end of the shelf is a white plastic sleeve, you have to pull that flat to the shelf which releases the edge from the body of the fridge, then tilt the shelf up & slide it out at an angle, we tour our caravan to, my hubby hated trying to reassemble ours after I scrubbed it all, he had walked away & said I can't fathom it, it drove him crazy for half hour before I realised what he was doing & showed him how, it's a stiff thing to do, but once you've worked out how, its ok, I know it's frustrating we didn't have the hand book for ours either ??

Dometic... | Answered on Sep 25, 2019


step 1: check the freon level via pressures or weighing in the correct amount.

Delfield... | Answered on Sep 24, 2019


It is a power supply smd 12 volt 6 A model S 126SMD3 it is craft by www.hanny.com.cn

Avanti... | Answered on Sep 24, 2019

Not finding what you are looking for?
Refrigerators Logo

173,238 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

Brad Brown

Level 3 Expert

18108 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...