Measuring Tools & Sensors - Recent Questions, Troubleshooting & Support

I have Acurite #75077A1. New sensor new batteries in both units. sensor not working tried to resync but no change?

Measuring Tools... | Posted Yesterday | Be the first to answer

I have Acurite #75077A1. New sensor new batteries will not talk to inside monitor. tried to resync but no change

Measuring Tools... | Posted Yesterday | Be the first to answer

I have a 8 hp Briggs and Stratton shredder, model 190432 type 6117 0-1 code9408191a. It starts and runs great bot it is leaking oilpretty bad from the front of the engine.Is there a fix for this?

Check oil level. If it's high and smells of fuel then likely the carb float is stuck or debris in inlet valve.

If oil level ok, then possibly a main shaft seal is out.

HP Measuring... | Answered Yesterday

1 Answer

I have a mitutoyo 500-422 and how do I replace the battery

I also have a Mitutoyo 500-422 Caliper. But mine is strictly solar powered. There is no battery for it. So long as you have 60 lux of illumination on it, it will work fine. Its not suited for darker environments, as it will lose its measurement when the light falls below 60 lux.

Mitutoyo... | Answered Yesterday

0 Answers

Can any external temperature sensor work with an Auriol Z31055A-RX temperature station

Measuring Tools... | Posted Yesterday | Be the first to answer

0 Answers

DigiWeigh DW100-AS. When following the calibration steps, when I out the 100g weight on, I get a ERRE code. Help?

DigiWeigh... | Posted 3 days ago | Be the first to answer

1 Answer

Validator nt-905 not starting, keep rebooting upon

Probably a power supply issue. Lack of power from it.

JDSU Test-um... | Answered 3 days ago

1 Answer

Our AcuRite is beeping every 30 seconds or so. We

I am skeptical of the "radio Interference" answer. The symbol on the lower left-hand of the panel indicates that it has received a signal from the sensor. My Receiver stops beeping if I stand between sensor (00739) and receiver (00734?). Perhaps they are too close. It took nearly a week for the sensor to indicate or transmit after Irinsed the battery compartment.

Acu-Rite AcuRite... | Answered on Oct 13, 2019

1 Answer

Why does laser not light

dead battery possibly

Ryobi Airgrip... | Answered on Oct 12, 2019

0 Answers

My digiweigh scale is a dw-100g cyber series. When I turn it on everything turns on right,but the scale will not measure anythings weight. I only used it twice and I haven't dropped it or mistreated it in anyway. The two objects I weighed was 2 grams or less. Is there anything I can do to fix it. I sure thought they was better equipment then it's turned out to be.....

DigiWeigh... | Posted on Oct 11, 2019 | Be the first to answer

1 Answer

Measuring distance of Craftman laser model 48252

They are advertised as 50 foot range, but the accuracy starts falling off past about 35 feet

Measuring Tools... | Answered on Oct 11, 2019

0 Answers

9640 weather station ice alarm How to turn off

Measuring Tools... | Posted on Oct 11, 2019 | Be the first to answer

1 Answer

What are the torque specs on intake manifold on Briggs & stratton

if there is thread locking compound on bolt or threads it must be removed, use a tap to clean the threads and a wire brush to clean the bolts. Use a thread locking compound (blue) when reassembling, torque the bolts to 30 ft. lbs. alternating bolt to bolt in 7-10 lb. increments. Recheck the torque after the engine has been ran up to op temp.

Briggs &... | Answered on Oct 10, 2019

0 Answers

The receiver stopped alarming

Dakota Alert... | Posted on Oct 10, 2019 | Be the first to answer

2 Answers

What is hookah?

A hookah is an instrument used to smoke shisha. Shisha is a type of flavored tobacco! Read more on Shisha Heart

Measuring Tools... | Answered on Oct 10, 2019

0 Answers

We have an older TopCon RL-HB laser. What would be the comparable TopCon laser to purchase to replace this model ?

Laser Measuring... | Posted on Oct 08, 2019 | Be the first to answer

0 Answers

Culligan water softener

Culligan... | Posted on Oct 07, 2019 | Be the first to answer

0 Answers

I have a Springfield Precise Temp M# 91505-1 and after changing batteries it will not sync. tried base unit and collector unit several times

Springfield... | Posted on Oct 06, 2019 | Be the first to answer

1 Answer

I need to replace the wind sensor for my Lacrosse WS-1912-IT weather station due to a hailstorm tearing of 2 of the wind cups...where can I order these from and be sure the new part fits? Roger

Order from LaCrosse.

Measuring Tools... | Answered on Oct 01, 2019

1 Answer

Pearl outdoor/indoor thermometer, can battery be replaced? If so, how?

can the battery be replaced. If so, how?
open the cover on the back of the device. this is done by squeezing the cover of the battery sector slightly. then remove the old batteries and replace the new ones (I assume you have the AAA) and put the new ones in keeping with the polarity for the device to work properly and then close the battery compartment cover in reverse order

Measuring Tools... | Answered on Sep 29, 2019

Not finding what you are looking for?

Brands:

11,962 questions posted

Ask a Question

Usually answered in minutes!

Are you a Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual

Measuring Tools & Sensors - Recent Questions, Troubleshooting & Support

I have Acurite #75077A1. New sensor new batteries in both units. sensor not working tried to resync but no change?

I have Acurite #75077A1. New sensor new batteries will not talk to inside monitor. tried to resync but no change

I have a 8 hp Briggs and Stratton shredder, model 190432 type 6117 0-1 code9408191a. It starts and runs great bot it is leaking oilpretty bad from the front of the engine.Is there a fix for this?

I have a mitutoyo 500-422 and how do I replace the battery

Can any external temperature sensor work with an Auriol Z31055A-RX temperature station

DigiWeigh DW100-AS. When following the calibration steps, when I out the 100g weight on, I get a ERRE code. Help?

Validator nt-905 not starting, keep rebooting upon

Our AcuRite is beeping every 30 seconds or so. We

Why does laser not light

Measuring distance of Craftman laser model 48252

9640 weather station ice alarm How to turn off

What are the torque specs on intake manifold on Briggs & stratton

The receiver stopped alarming

What is hookah?

We have an older TopCon RL-HB laser. What would be the comparable TopCon laser to purchase to replace this model ?

Culligan water softener

I have a Springfield Precise Temp M# 91505-1 and after changing batteries it will not sync. tried base unit and collector unit several times

I need to replace the wind sensor for my Lacrosse WS-1912-IT weather station due to a hailstorm tearing of 2 of the wind cups...where can I order these from and be sure the new part fits? Roger

Pearl outdoor/indoor thermometer, can battery be replaced? If so, how?

Not finding what you are looking for?

Brands:

Ask a Question

Popular Products

Briggs & Stratton Briggs Stratton Intek V - Twin...

Robinair Cool Tech 34700Z Recovery, Recycling,...

RTO Automatic Transmission And Engine Oil Pressure...

Culligan Sediment Water Filter

Reddy Heater 60,000 BTU Kerosene Forced-Air Heater...

Top Measuring Tools & Sensors Experts

Vuk B

Brad Brown

Tom Chichester

Are you a Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Manuals & User Guides

Manual refractometro.pdf....

Dimension-Pro-Instructions.pdf....

Dimension-Pro-Instructions.pdf....