Irons - Recent Questions, Troubleshooting & Support


not a clue if the mfg does not supply them

Irons | Answered Yesterday


Aply colgate on the surface of the iron, waite few minutes for it to stick thoroughly then srub it off with a cloth. It comes off with the dirt..

colgate-kal2dhwsrgst4ybfqk15ysyp-5-0.jpeg

Irons | Answered 2 days ago


The heating element or its control circuit could be at fault.

Irons | Answered on Feb 14, 2019


Low water sensor is the beep.have you tried re filling it?...the manual is at this web site:
https://issuu.com/laurastar/docs/instruction_manual_laurastar_lift_e

Irons | Answered on Feb 14, 2019


I had the same problem. The solution was quite simple actually. I took the iron apart. The problem was that one wire got loose. I soldered it back where it belongs and now the iron works again.
CAUTION! This procedure should be done by a qualified electrician only!

straighteners-keep-turning-off-kqgwre2wsiijqd4rfxpaqyqf-3-0.jpg

Remington S9500... | Answered on Feb 13, 2019


You are probably not holding the iron the right way! Don’t hold the iron upside down, or don’t put too much water in at a time. Make sure that the heat on iron is turned up hot enough to burn the water fast enough so it doesn’t leak.

Irons | Answered on Feb 12, 2019


flush it with vinegar

Philips Irons | Answered on Jan 29, 2019


The display is flashing constantly?

It likely has a "defective" thermal fuse, same junk part that fails in perfectly good coffee makers.

Irons | Answered on Jan 29, 2019

Not finding what you are looking for?
Irons Logo

9,043 questions posted

Ask a Question

Usually answered in minutes!

Top Irons Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Brad Brown

Level 3 Expert

17972 Answers

Marvin
Marvin

Level 3 Expert

83951 Answers

Are you an Iron Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...