Question about 2000 Jeep Grand Cherokee

3 Answers

Voltage gauge periodically drops from 14 volts to 9 volts every couple of minutes and then it will go back up after you turn the heat off, with no other changes to lights or the engine. Also the tempature gauge starts rising after about 20 minutes of the truck running. Is this the altenator and maybe a theromostat?

Posted by on

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Jeep Expert
  • 165 Answers

I had this happening on my 2004 GC and it was the alternator brush block worn to limits. You can get a new brush block, or a complete new alternator. There is also a good change that your battery is going bad due to the alternator. 9V only indicates a dead battery cell.
Does the engine temperature rise while driving, or when standing still only? In the first case, I would first expect the thermostat, in the second case the cooling fan is most probably not working.

Posted on Dec 16, 2017

Ad

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 30 Answers

I believe you have two separate problems sounds like an alternator possibly going bad regular inside it internal, and you may have electric cooling fan not coming or bad fan or sensor or possibly plugged up radiator

Posted on Dec 10, 2017

Ad

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 5 Answers

I would say the alternator. The fluctuations when it is running indicate that the regulator inside the alternator is worn out. The overheating is probably because the cooling fan is not running fast enough or at all.

Posted on Dec 10, 2017

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Anonymous

  • 4 Answers

SOURCE: Voltage Gauge drops suddenly to zero

Charging system grounding out, poss inside alternator

Posted on Jan 31, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: Oil pressure gauge drops after running and sitting still

The Oil pressure sensor seams to have gone bad and needs to be replaced soon as possible as they tend to leak oil soon after. There common to go bad and start with that since it's easier then replacing the oil pump, but if you don't hear any ticking from the engine and you have good pressure when the engine is cold then it's the sensor. 
The 4 cylinder oil pressure switch is located below the A/C compressor. It is a single wire connection with a gray/yellow striped wire. 

The 6 cylinder oil pressure switch is located on the passenger side rear of the block. It is a single wire connection with a gray/yellow striped wire. 

Good luck and hope this helps. 

Posted on Jul 01, 2009

csmock132

Clint Smock

  • 4669 Answers

SOURCE: Tempature Gauge High

Check the cooling fan.

Posted on Jul 05, 2009

Anonymous

  • 490 Answers

SOURCE: voltage gauge drops below 14 volts when vehicle

have your battery tested perform a Load test it has to hold at least 12.4 volts to be excelent,you can get away with 11.8 or 11.9 and it will still be good,any lower replace it.
also on a jeep 13.2 and up is okay,with everything on.
Any lower than that you have a problem in your wires.Check at the alternator,if iot looks good then you need more help.

Posted on Aug 10, 2009

Richard Scordino

  • 6982 Answers

SOURCE: check engine light flashes and engine stalls at

Make sure that your battery cable contacts are clean and secure at both ends including any body grounds especially at both fenders, firewall and dashboard lower brace. If all is good, likely your alternator is failing. Be aware: some of those charging systems have the voltage regulator as an integral part of the computer, not in the alternator. If you find that the alternator checks out and the wiring for it is intact and its connections are clean, there is a possibility that the regulator has failed. If so, the computer needs to be changed. You don't necessarily need to get a new one as most are available much cheaper in a scrapyard (Id get one that was in an accident...ones with perfectly good bodies may have had engine problems otherwise they would still be on the road!

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The volt gauge reads 14 volts when the truck is running (2004 Chevy 2500 HD, 6 Liter) after I shut it off Voltage gauge reads 9 volts as low as the gauge goes. The starter acts like it is not getting...


14 volts is close (14.5-14.8 volts is required
and 9 when shut down indicates a bad battery
have it load tested and then have the alternator tested for rectifier pack operation
there should be 14.5 volts DC at the battery when running or it is not charging the battery
if you have 14 volts AC replace the alternator with a serviceable unit

Aug 08, 2017 | 2004 Chevrolet Silverado 2500HD

1 Answer

I have a 2002 ford ranger that got a lot of water in the gas. I have drained the tank and added heat as well as replaced the filter. When I try to start it the battery gauge goes down to 0 and all I hear...


The alternator isn't charging , check B+ voltage hook-ups on the alternator . The heavy gage wire on the back of the alternator should have B+ voltage , vehicle not running . The fuel pump has nothing to do with it > terminal 3 at the connector should also have B+ voltage , So should terminal 1 . Charge the battery an get the vehicle running , put a volt meter on the battery post's , if there is about 13 to 14 volts running it is not charging !
How to Test an Alternator Diagnose Charging Issues

Apr 19, 2017 | 2002 Ford Ranger Regular Cab

2 Answers

I HAVE A 1994 BUICK REGAL,WHEN I START THE VEHICLE THE AMP GAUGE STAYS AT ABOUT 6 VOLTS,AND THEN I TURN ON THE PARKING LIGHTS AND IT GOES TO NORMAL ABOUT 14,I TURN OFF THE PARKING LIGHTS AND IT STAYS ON...


replace the voltage regulator
amp gauges read amps or current flow
volte gauges read volts so if the volt gauge reads 6 with the engine running indicates that the regulator is not coming into service until the battery voltage drops and that triggers the regulator
an accredited auto electrician will be able to test the complete charging system and advise on the fault

Nov 20, 2017 | Cars & Trucks

1 Answer

Just installed new battery and gauge still drops below 14 amps when i put on a/c,use power windows and has stalled while driving a couple of times


The problem will be in the alternator,it is not charging enough,and it is on it`s way out,If this was at all helpful,please rate,the voltage at the battery should read with a volt meter,13.65 volts to 14.25 volts with the headlights are turned on,and ac on high blower motor.If it is not in this range,replace the alternator.

Jul 12, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

I have a 2004 Hyundai elantra. When driving all my gauges turn off including my odometer and speedometer. My car loses power and the automatic trans. has trouble shifting. My battery completely dies,...


I am having the same problem with my 2004 Elantra. I have had the alternator tested twice and did replace the battery. This morning I had it running ad put a volt meter on it ( red to the battery pos black to the engine block) I did get a reading of 14 volts for about 30 seconds then the idle lowered and the voltage dropped to 12 volts. I tried this again later but could not get a voltage reading above 12 volts with the motor running. Any suggestions?

Jun 28, 2010 | 2004 Hyundai Elantra

1 Answer

Voltmeter drops to 9 volts on Chev 454 P30 motorhome


this is eithere a loose positive cable from the altenator to the battery or the regulator in the altenator is about to fail. if you have not had any problems starting the vehicle then most likely its a loose connection between the gauge and the charginging circuit or the gauge is faulty. take a multimeter and test the charging votage at the altenator while the vehicle is running it should measure 13.5 volts and should not change more than .5 volts. if the voltage drops more than 1 volt the regulater is bad and the altenator needs to be replaced. if it is working fine then looke for a bad connection make sure all positive and ground cables are tight. if they are replace amp gauge

Apr 19, 2009 | 1994 Chevrolet C/K 3500

1 Answer

When I turn the ignition on the battery light comes on and the voltage gauge drops between 9 & 14. Then it slowly goes up to around 14. I replaced the battery. Alternator??


take volt meter check voltage on batt.while truck is idling,voltage should be between 13.5-14.5v,turn headlights on it should stay in that range if it goes below,check for bad wire connection at alt.,if conn. are ok,theres a good chance alt. not charging properly!before doing test make sure batt.is full charge!

Apr 19, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Battery voltage dropping


I would take the alternator of and have tested. There is a good chance this is your problem. Auto Zone will test it for free It will not take long to remove 20 minutes or so only basic tool are required. If you can not get it tested I would dare say that it is a safe bet that this is your problem.

Jan 09, 2009 | 1998 GMC Jimmy

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...