Question about Cars & Trucks
Fuel filter, pump replaced. Dist cap and wires replaced. MAP replaced, Throttle position sensor replaced. No cat present. EOM replaced, worse. Supposedly pre programed. Engine light on and Amp needle buried far right with new EOM.
Any problem before, plugs, wires, coils???Any codes? This could create a problem.
Posted on Jan 13, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2000 td 2.5 Jeep Cherokee sport
Seems like you might have wet the no 1 injector sensor..(little black plastic thing with 2 wires) It sends a pulse back to ecu and if wet it,s no good....
Posted on Nov 08, 2008
Your catalytic converter is plugged up,
If you check the exhaust output at the tailpipe you will find it restricted.
Let me know if I can assist further.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee
Posted on May 08, 2009
Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!
Posted on Jun 27, 2009
SOURCE: I am experiencing power loss
these vehicles are known for ignition coil failure. typical symptoms include: Misfire, power loss, vibrating engine, poor fuel consumption. If the vehicle's engine vibrates, it be misfiring. Is your chk engine light on???
Posted on Sep 29, 2010
Thanks for choosing FixYa and welcome to the site. To be honest with you, there are many things that can cause a rough idle and power loss. I will tell you everything you need to check. Check to see if you have any vacuum leaks. Make sure your air filter and fuel filter are not clogged. If you haven't had a tune up in a long time, you need to have it done. Change your spark plugs.coils, wires, distributor cap, coil packs. Change your fluids if possible as well. You want to make sure to check your pcv valve also. Inspect all wires and hoses to make sure they are not damaged. And lastly, make sure the battery is good and holding a proper charge. Make sure the terminals are cleaned. If your parts are not getting the proper voltage, your vehicle will not perform like it should. If you have any questions, feel free to ask and thanks for using FixYa.
Posted on Apr 14, 2011
Testimonial: "thanks so much!!!!!"
Tips for a great answer:
Dec 25, 2015 | Ford Cars & Trucks
Feb 22, 2015 | 1996 Jeep Grand Cherokee
Dec 06, 2013 | Oldsmobile Cutlass Ciera Cars & Trucks
Oct 02, 2013 | 1992 Jeep Cherokee Sport
Feb 27, 2012 | 1992 Honda Accord
Dec 20, 2017 | 1996 Jeep Cherokee Sport
Mar 13, 2017 | 1992 Jeep Cherokee Sport
Jan 16, 2010 | 1992 Jeep Cherokee Sport
Dec 12, 2009 | 1992 Jeep Cherokee Sport
Sep 22, 2009 | Jeep Cherokee Cars & Trucks
Jan 18, 2019 | Ford Focus Cars & Trucks
23 people viewed this question
Usually answered in minutes!