Question about 2011 Chevrolet Equinox
Posted by Anonymous on
Hope this help
Posted on Mar 09, 2015
The crankshaft position sensor is located just above the starter and underneath the oil filter housing and is held in with one bolt. When you remove the bolt, pull straight out of the block with a twisting motion. Do not rock it back and forth, otherwise it will break off. If you have difficulty, spray carb cleaner or brake clean to dissolve the varnish.
Posted on Oct 13, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
Posted on Mar 26, 2009
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
Posted on Jun 13, 2009
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A magnetic crankshaft sensor (Hall Effect switch) is used which is remotely mounted on the opposite side of the engine from the DIS/IC module. The sensor protrudes in to the engine block, within about 0.050 in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Posted on Sep 25, 2009
Testimonial: "Awesome. Thanks."
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
Posted on Mar 22, 2010
Tips for a great answer:
Aug 27, 2016 | 2011 Chrysler Town and Country
Jan 27, 2016 | Lexus Cars & Trucks
Jan 01, 2016 | 2007 Chevrolet Chevrolet Equinox LT
Aug 26, 2015 | Cars & Trucks
Oct 17, 2014 | 2012 Chevrolet Equinox LS 4dr SUV 2.4L...
Oct 12, 2014 | 2011 Chevrolet Equinox
Apr 03, 2014 | 2011 Kia Forte
Mar 22, 2010 | Chevrolet Malibu Cars & Trucks
1,503 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: